It is the time taken by a bit to go through the network and back. When the first bit of the output frame is seen on the output port. When the last bit of the input frame reaches the input port and ends (for store-and-forward devices) refers to the time interval that begins Translates the obtained rate into the available bandwidth of the service. Test calculates the maximum rate at which none of the offered framesĪre dropped by the device/system under test (DUT/SUT).This measurement Methodology types that you can use to test, measure, and report performance The following are some of RFC 2544 benchmarking tests Sent to a device that functions as a reflector, which receives and Initiator (which is also called the originator). Test packets from a device that functions as the generator or the Transmission delay, link burstability and service integrity measurements,Ī carrier can certify that the working parameters of the deliveredĮthernet circuit comply with the contract.Īn RFC2544-based benchmarking test is performed by transmitting The RFC 2544 methodology can be used to measure various parametersīased on SLA agreements and certify it. Test time for each test iteration, and the frame format (UDP-over-IP). Various parameters such as different frame sizes to be examined, the The test methodology enables you to define These tests measure throughput, latency, frame loss To measure and report the performance characteristics of network devicesĪnd services. Test methodology defines specific set of tests that operator can use
0 Comments
Leave a Reply. |